Table of Contents
Advertisement
8
Boiler installation
Screw studs included with the B-Kit to the burner
door.
Fit the burner to the hole circle of the burner door.
NOTICE
Approved burners with accessories (such
as aquastat and circulator) are also
available as a package from Buderus
Hydronic Systems.
Install burner with the correct nozzle and settings
(air, pump pressure, turbulator settings, flange
position).
Place the seal on the studs and secure the burner
with the included nuts.
Follow the manufacturer's direction for installation,
fine adjustment and regular maintenance
procedures.
NOTICE
For the correct burner settings see the
documentation for the flue system and
the
burner.
Wire up the burner (see
burner).
8.5
Providing a fuel supply
Make the fuel connection in accordance with all locally
applicable regulations. We recommend the installation
of a fuel filter.
Visually inspect the fuel pipe and clean or replace, if
necessary.
Install a shut-off valve into the fuel supply pipe.
Connect the fuel pipe free of stress to the boiler.
Check the fuel line for leaks.
8.6
Aquastat installation
An aquastat controls the boiler supply temperature.
Install aquastats in the sensor well as specified by
the installation manual.
For operating the boiler with aquastat
page 42.
38
Installation and maintenance instructions Logano G215 US oil/gas-fired boilers • Issue 11/2004
documentation for
Chapter 9,
Fig. 51 Burner door mounting holes
1
Fig. 52 Aquastat installation
1 Sensor well
We reserve the right to make any changes due to technical modifications.
4 3/8"
5 7/8"
Hide quick links:
Advertisement
Table of Contents
