Buderus Logano G215 US Installation And Maintenance Instructions Manual page 21

Boiler block assembly
BOILER DAMAGE
due to leaking boiler sections.
For each compression procedure
CAUTION!
ensure that no more than one nipple
joint (one nipple joint comprises two
sections) is compressed.
Never jam nipples into the boiler hubs of
the boiler section.
Stop pressing the sections together
when the boiler hubs meet.
Release and remove the compression tool.
Hammer the nipples into the partly assembled boiler
block ( Chapter 7.1.2, page 17).
Prepare all other intermediate sections as described
above and join them at the nipples.
Fitting the front section
Due to the threaded studs, do not use the auxiliary
flange at the front of the upper boiler hub when
assembling the front section.
Push the pull rod together with the compression unit
through the upper boiler hub.
Carry out all other steps as described
( Chapter 7.1.7, page 19)
We reserve the right to make any changes due to technical modifications.
Installation and maintenance instructions Logano G215 US oil/gas-fired boilers • Issue 11/2004
Fig. 16 Fit the compression tool to the front section
7
21