Altitude Administration; Setting Altitude - Fujitsu SPARC EnterpriseM3000 User Manual

2.2.17

Altitude Administration

This section explains the altitude settings. The server changes the system monitoring
due to the altitude of the server. Therefore, the operator must set the altitude during
the initial system setting. This setting is done by FEs.
With the altitude setting, the fan speed level varies by the environmental
temperature. To display the fan speed level for each environmental temperature,
execute the showenvironment(8) command. For the fan speed level corresponding
to the altitude and the environmental temperature, see
System Information" on page
TABLE 2-36
Altitude Administration
TABLE 2-36
Item Description
Display settings Display the altitude settings for the server.
Altitude Specify the location altitude of the server:
A set unit is specified in increments of 100 meters.
The setting of less than 100 meters is rounded up.

Setting Altitude

■
1. Use the showaltitude(8) command to check the current altitude settings.
XSCF> showaltitude
1000m
2. Use the setaltitude(8) command to set the altitude settings.
<Example 1> Specify an altitude of 1000 meters
XSCF> setaltitude -s altitude=1000
1000m
<Example 2> Specify an altitude of 200 meters
XSCF> setaltitude -s altitude=200
200m
Note – To apply the specified configuration, execute the rebootxscf(8) command
and reset XSCF.
lists setting items and the corresponding shell commands.
Command operation
4-2.
Shell Command
showaltitude
setaltitude
Section 4.1.1, "Displaying
Remarks
A negative altitude
cannot be set.
Chapter 2 Setting Up XSCF 2-191