Fujitsu SPARC EnterpriseM3000 User Manual page 373

System and Domain Operation
TABLE 9-6
Select [Operation]-[Domain Operation]-[Domain Power] in the Menu tree.
System and Domain Operation
TABLE 9-6
Function
System power on/off
Domain power-on/off
Reset
Send break
Note – In the M3000 server, the number of the target domain is one. Domain ID is
fixed to 00.
TABLE 9-7
[Operation]-[Domain Operation]-[Domain Mode Configuration] in the Menu tree.
Domain Mode Configuration
TABLE 9-7
Function
Domain mode configuration/display
lists the function used for the system as a whole and individual domains.
lists the functions used for specifying each domain mode. Select
Remarks
Sets a hardware initial diagnostic level. Suppresses
the send break, Host watchdog, and automatic boot
functions. Also, displays the host ID, the domain
mode status, and domain ethernet address (mac
address).
This function is equivalent to the
setdomainmode(8) and showdomainmode(8)
commands.
On the XSCF Web, you cannot display/configure
the CPU operational mode. Use the
showdomainmode(8) and setdomainmode(8)
commands.
Remarks
Specifies the system power on/off.
This function is equivalent to the poweron(8) /
poweroff(8) commands.
Specifies the domain power on/off.
This function is equivalent to the poweron(8) /
poweroff(8) commands.
System reset, XIR reset and panic for the domain are
performed. This function is equivalent to the reset(8)
command.
Specifies the send break.
This function is equivalent to the sendbreak(8)
command.
Chapter 9 How to Use the XSCF Web 9-13