Table of Contents
Advertisement
2. Use the showad(8) command to display the diagnostic messages.
<Example> Displays diagnostic messages in real time.
XSCF> showad log -f
Mon Nov 16 14:47:53 2009 (ActDir): module loaded, OPL
Mon Nov 16 14:47:53 2009 (ActDir): --error-- authentication status:
auth-ERROR
Mon Nov 16 14:48:18 2009 (ActDir): module loaded, OPL
...
3. Use the setad(8) command to clear the log file of diagnostic messages.
XSCF> setad log clear
Warning: About to clear log file.
Continue? [y|n]: y
Change the Active Directory Settings Back to the Default
Command operation
■
1. Use the showad(8) command to display the Active Directory settings.
XSCF> showad
dnslocatormode: enabled
expsearchmode: enabled
state: enabled
strictcertmode: enabled
timeout: 10
logdetail: trace
2. Use the setad(8) command to change the Active Directory setting back to the
default.
XSCF> setad default -y
Warning: About to reset settings to default.
Continue? [y|n]: y
Chapter 2
Setting Up XSCF
2-69
Advertisement
Table of Contents
