3.3
Group Administration (IBP)
3.3.1
Uplink Set
This section contains the Uplink-Set module messages.
Error Message
Explanation
Recommended Action
Error Message
Explanation
Recommended Action
Error Message
Explanation
Recommended Action
Error Message
Explanation
Recommended Action
Error Message
Explanation
Recommended Action
Error Message
Explanation
Recommended Action
Error Message
Explanation
Incorrect input! Use 'uplink-set <uplinkSetName>'.
Incomplete command for this function.
Use complete command 'uplink-set <uplinkSetName>'.
Incorrect input! Use 'no uplink-set <uplinkSetName>'.
Incomplete command for this function.
Use complete command 'no uplink-set <uplinkSetName>'.
Incorrect input! Uplink Set name can not more than 32
characters.
User input an Uplink set name, the length of name exceeded 32
characters.
The length of the Uplink set name should less than 32
characters.
Incorrect input! Uplink Set name must contain alphanumeric
characters only.
User input non alphanumeric characters for Uplink set name.
Use alphanumeric characters for the Uplink set name.
Incorrect input! Uplink Set <uplinkSetName> has been used!!
User try to create a new Uplink Set that has already exist in the
system.
Use the correct Uplink Set name for this function.
Incorrect input! Uplink Set <uplinkSetName> does not exist!!
User input an Uplink set name, but the Uplink set doesn't exist.
Use the correct Uplink set name for this function.
ERROR: Uplink Set table is full.
User try to create a new Uplink Set, but the Uplink Set table has
reached the maximum.
2011 Fujitsu Technology Solutions
©