Canon imagePROGRAF iPF8400S User Manual page 537

iPF8400S
5
Press ▲ or ▼ to select Width Detection, and then press the OK button.
6
Press ▲ or ▼ to select Off, and then press the OK button.
Load paper in the desired position to start printing from
Follow these instructions to load paper at the desired starting position for printing when Width Detection is Off.
1
If you did not send a print job in advance, a menu for selection of the type of paper is displayed.
Press ▲ or ▼ to select the type of paper, and then press the OK button.
• If a print job was received before paper was advanced, the media type and size specified by the job are shown on
the Display Screen.
Note
Go to step 2.
2
"Width Detection OFF. OK to continue?" is now shown on the Display Screen. Press ▲ or ▼ to select
"Leave OFF", and then press the OK button.
3
After a menu for selection of the paper size is displayed, press ▲ or ▼ to select the paper size, and then press
the OK button.
4
Open the Top Cover and check the position where pa-
per is loaded.
To start printing from the current position, close the Top
Cover.
To reposition the paper, lift the Release Lever.
User's Guide
Printing From a Desired Starting Point
537