End Of Paper Feed; Rel Lever Is In Wrong Position; Rewinding Error; Media Take-Up Unit Ready - Canon imagePROGRAF iPF8400S User Manual

iPF8400S
Cause
There is a foreign object by the
Output Tray, obstructing the
Cutter Unit.
You are not using the printer
under the recommended envi-
ronmental conditions for the
paper.
You are using paper that is not
compatible with automatic cut-
ting.
In other cases, the Cutter Unit
may be damaged.

End of paper feed.

End of paper feed.
Although an attempt was made to advance the paper manually, it reached the limit position
that can be advanced.
Paper can be retracted only up to 17 mm (0.7 in) when using the Media Take-up Unit.

Rel lever is in wrong position.

Rel lever is in wrong position.
Cause
The Release Lever is up. Lower the Release Lever.
If the error occurs again, turn off the printer and wait a while before restoring power.

Rewinding error.

Rewinding error.
There is some foreign object near the Media Take-up Unit sensor and
the roll cannot be detected.
The roll is out of range of detection by the Media Take-up Unit sensor.
A paper jam has occurred and the roll cannot be rewound.
The Media Take-up Unit sensor is damaged.
*1: Printing will stop momentarily if an error involving the Media Take-up Unit occurs. If you prefer printing not to stop, set Skip Take-Up Err
to On. However, note that this error may cause paper jams and affect the printing quality.

Media take-up unit ready.

Media take-up unit ready.
Cause
The Take-up Reel setting in the printer Set./Adj. Menu was
changed from Enable to Disable, but a print job was re-
ceived before the roll was removed.
User's Guide
1.
Lift the Top Cover and remove the foreign object.
2.
If "Not finished printing. Finish printing remaining jobs?" is shown on the Display Screen, press the
OK button.
Printing will resume, starting from the page on which the error occurred.
Use the printer only where the recommended environmental conditions for the paper are met. Note that vari-
ous environmental conditions are recommended for various types of paper. For details on the recommended
environmental conditions, see the Paper Reference Guide.
(See "Displaying the Paper Reference Guide.")
1.
Specify Manual as the cutting method and use scissors or a cutting tool to cut the roll.
(See "Specifying the Cutting Method for Rolls.")
For information about paper that is compatible with automatic cutting, see the Paper Reference Guide.
(See "Displaying the Paper Reference Guide.")
2.
Lift the Release Lever and remove the paper.
Contact your Canon dealer for assistance.
Cause
Corrective Action
Cause
Press ▲ or ▼ to select Stop Printing, and then press the OK button to stop
printing.
The mode switches from take-up mode to regular mode after you change the
Take-up Reel setting in the Set./Adj. Menu from Enable to Disable and lift the
Release Lever to remove a roll, or after you execute Paper Cutting.
Corrective Action
P.501
➔
P.523
➔
P.501
➔
Canceling manual advancing.
(See "Feeding Roll Paper Manually.")
Canceling manual advancing.
Corrective Action
Remove the foreign object near the sensor.
Reload the roll.
Press the OK button to clear the error.
(See "Loading Rolls in the Printer.")
(See "Loading the Rewind Spool on the Media Take-up Unit.")
Remove the paper from the Media Take-up Unit.
Press the OK button to clear the error.
Contact your Canon dealer for assistance.
Corrective Action
End of paper feed.
Corrective Action
P.521
➔
P.510
➔
P.550
➔
963