Menu Settings - Canon imagePROGRAF iPF8400S User Manual

iPF8400S

Menu Settings

Menu Settings
Menu items are as follows.
The printer menu is classified into regular menu items available when no print job is in progress and menu during print-
ing items only available while printing is in progress. see "Printer Menu Operations."
Regular menu
Paper Menu
Ink Menu
Job Menu
Set./Adj. Menu
*1: Only displayed in the menu during printing. Not displayed in the regular menu.
For instructions on selecting menu items, see "Menu Operations."
For details on the displayed menu hierarchy, see "Menu Structure."
Paper Menu
The Paper Menu is not displayed during printing.
Setting Item
Load Paper
Eject Paper
Chg. Paper Type ( *1 )
Chg. Paper Size
ManageRemainRoll
Paper Details (The type of paper
is displayed here.)
( *1 )
User's Guide
Menu during printing
Not displayed
The same Ink Menu as normal is displayed.
The same Job Menu as normal is displayed.
A limited Set./Adj. Menu containing the following items is displayed.
•
Adj. Fine Feed ( *1 )
•
Printer Info
➔
Select either sheets or rolls and load the paper.
Choose this item before removing loaded paper.
Change the type of paper loaded. (See "Changing the Type of Pa-
per.")
P.514
➔
Change the size of paper loaded. (See "Specifying the Paper
Length.")
Choose On to print a barcode at the end of a roll before you remove it.
The printed barcode can be used in managing the amount of roll paper
left. Choose Off if you prefer not to print the barcode.
(See "Keeping Track of the Amount of Roll Paper Left.")
Head Height Adjust the Printhead height. (See "Troubleshooting Paper Abrasion and
Blurry Images.")
Skew Check Lv. If you print on Japanese paper (washi) or other handmade paper that
has an irregular width, choose Loose for a higher skew detection
threshold, or choose Off to disable skew detection. However, if paper is
loaded askew when detection is Off, note that paper jams or Platen
soiling may occur.
Cutting Mode Specify whether or not to cut with the standard round-bladed cutter.
If you choose Automatic, the roll will be cut automatically using the
Cutter Unit, depending on the printer driver settings.
Select Eject to prevent printed documents from falling immediately after
printing such as when you wait for the ink to dry, etc. Manual prints
lines at the cut position instead of cutting after printing. If you select
Manual, the setting screen for detection of the paper leading edge is
displayed.
(See "Specifying the Cutting Method for Rolls.")
Cut Speed Choose the cutting speed. The preset selection represents the optimal
cutting speed for the type of paper. We recommend keeping the preset
cutting speed.
If you use adhesive paper, choosing Slow helps prevent adhesive from
sticking to the cutter and keeps the cutter sharp.
P.631
➔
P.632
P.635
➔
Description, Instructions
(See "Paper Sizes.")
P.516 P.496
➔ ➔
P.773
➔
Menu Settings
P.521
➔
P.523
➔
641