Insufficient Paper For Job; This Paper Cannot Be Used As Size Is Not Supported - Canon imagePROGRAF iPF8400S User Manual

iPF8400S
Paper has been loaded askew, or warped paper has been loaded.
Because the Platen is soiled with ink or other substances, the size of the clear film cannot
be detected.

Insufficient paper for job

Insufficient paper for job
The printer has received a print job longer than the amount of roll paper left when
ManageRemainRoll in the Control Panel menu is On.

This paper cannot be used as size is not supported.

This paper cannot be used as size is not supported.
Cause
Paper that is too large for the printer has been loaded.
Paper that is too small for the printer has been loaded.
Paper has been loaded that is too small to print the
test pattern for printhead adjustment or nozzle check-
ing.
User's Guide
Cause
Cause
Lift the Release Lever and load paper of the correct size.
(See "Paper Sizes.")
Lift the Release Lever and load paper of the correct size.
(See "Paper Sizes.")
Lift the Release Lever and load unused paper A4/Letter (vertical) or larger. More than
one sheet may be required depending on the adjustment.
Corrective Action
If this error recurs after you reload the roll, re-
move the Roll Holder from the printer, push the
roll firmly in until it touches the Roll Holder
flange, and reload the Roll Holder in the print-
er.
(See "Attaching the Roll Holder to
Rolls.")
P.507
➔
Open the Top Cover and clean the entire Plat-
en.
(See "Cleaning Inside the Top Cov-
er.")
P.907
➔
Corrective Action
Press ▲ or ▼ to select Print, and then press the OK
button to resume printing.
When using the Media Take-up Unit, press ▲ or ▼ to
select Print, and then press the OK button to resume
printing.
However, the roll paper may run out during the print job
and you may not be able to print all of the document.
Press ▲ or ▼ to select Change Paper, and then press
the OK button.
Change the Paper Source of the printer driver, or re-
place the roll with a roll that has enough paper for the
print job, and then printt.
When using the Media Take-up Unit, press ▲ or ▼ to
select Stop Printing, and then press the OK button to
stop printing.
Remove the printed document from the Media Take-up
Unit, replace the roll with a roll that has enough paper
for the print job, and then try printing again.
(See "Removing the Roll from the Printer.")
(See "Loading Rolls in the Printer.")
(See "Removing Printed Documents from the Media
Take-up Unit (Optional).")
Press ▲ or ▼ to select Stop Printing or press the Stop
button to stop printing.
Corrective Action
P.496
➔
P.496
➔
Insufficient paper for job
P.517
➔
P.510
➔
P.557
➔
959