Initial Settings; Configuring The Ip Address On The Printer; Configuring The Ip Address Using The Printer Control Panel - Canon imagePROGRAF iPF8400S User Manual

iPF8400S

Initial Settings

Initial Settings
Configuring the IP Address on the Printer ................................................................................................................ 679
Configuring the IP Address Using imagePROGRAF Device Setup Utility ............................................... 701
Configuring the IP Address Using the Printer Control Panel ....................................................................... 679
Configuring the IP Address Using ARP and PING Commands .................................................................... 680
Configuring TCP/IPv6 Network Settings .................................................................................................................... 682
Configuring the Printer Driver Destination (Windows) ......................................................................................... 682
Configuring the Printer Driver Destination (Mac OS) ............................................................................................ 683
Configuring the Printer's TCP/IP Network Settings With RemoteUI .............................................................. 683

Configuring the IP Address on the Printer

Configuring the IP Address on the Printer

You must configure the printer's IP address before using the printer in a TCP/IP network.
The printer's IP address is configured automatically when you install the printer driver following the instructions in the
Setup Guide.
Configure the IP address by using imagePROGRAF Device Setup Utility, the printer Control Panel, or ARP or PING
commands, if the IP address is changed, or if you change the printer connection mode to a network connection. For
details on configuring the IP address, refer to the following topics.
Configuring the IP Address Using imagePROGRAF Device Setup Utility
•

Configuring the IP Address Using the Printer Control Panel

•
Configuring the IP Address Using ARP and PING Commands
•
• If you use a DHCP server for automatic assignment of the printer's IP address, printing may no longer be possible after the
printer is turned off and on. This is because an IP address different from before has been assigned. Thus, when using DHCP
Important
server functions, consult your network administrator and configure the settings in one of the following ways.
• Configure the setting for dynamic DNS updating
In the printer menu, either set DNS Dync update to On, or activate the setting Enable DNS Dynamic Update in RemoteUI.
(See "Menu Settings.")
(See "Configuring the Printer's TCP/IP Network Settings With RemoteUI.")
Configure the setting for assignment of the same IP address each time the printer starts up
•
• We recommend configuring the printer's IP address even if you will use the printer in networks other than TCP/IP networks.
Configuring the printer's IP address enables you to use RemoteUI to configure the network settings and manage the printer
Note
with a web browser.
For details on RemoteUI, see "Using RemoteUI."

Configuring the IP Address Using the Printer Control Panel

Configuring the IP Address Using the Printer Control Panel
This topic describes how to configure the printer's IP address on the Control Panel.
1
On the Tab Selection screen of the Control Panel, press ◀ or ▶ to se-
lect the Settings/Adj. tab (
User's Guide
P.641
➔
P.677
➔
).
Configuring the IP Address on the Printer
(Windows)
P.701
➔
P.679
➔
P.680
➔
P.683
➔
679