The Size Of Clear Film Cannot Be Detected; Margins Are Wide - Canon imagePROGRAF iPF8400S User Manual

The size of clear film cannot be detected

The Media Take-up Sensor cord is not connected to the Right Media Take-up
Unit correctly.
The size of clear film cannot be detected
The size of clear film cannot be detected
The Platen is soiled with ink or other substances.

Margins are wide

Margins are wide
Rolls are advanced a specific amount before cutting to
prevent problems with cutting and paper ejection.
When Cutting Mode in the Control Panel menu was set
to Manual, you selected Do not perform in response to
the "Perform the detection of paper leading edge?"
message.
930
Cause
Cause
Open the Top Cover and clean the entire Platen.
(See "Cleaning Inside the Top Cover.")
Cause
Remove the foreign object from the Media Take-up Sensor
path. Arrange the Basket Cloth and Basket Rod so they do
not interfere with the Media Take-up Sensor.
Reconnect the Media Take-up Sensor cord as follows.
1.
Turn the printer off.
2.
Disconnect the Media Take-up Sensor cord from the
Right Media Take-up Unit and reconnect it firmly, all the
way in.
3. Turn the printer on.
(See "Using the Media Take-up Unit (Optional).")
If the Media Take-up Unit continues rotating, contact your
Canon dealer for assistance.
Corrective Action
➔
This operation is normal.
Set Cutting Mode to Manual again, and select Perform(recommend) when the
"Perform the detection of paper leading edge?" message is displayed.
Note that when you select Perform(recommend), if the paper is strongly curled,
the Printhead may rub against the leading edge of the paper when the printing
starts.
(See "Specifying the Cutting Method for Rolls.")
Corrective Action
P.907
Corrective Action
P.523
➔
iPF8400S
P.548
➔
User's Guide