The Rear Panel Of The Vs-2000 - Roland VS-2000 Owner's Manual

2—Getting Around

The Rear Panel of the VS-2000

14 15
1 3 5 7 9 11 13
2 4 6 8 10 12
1—Grounding Terminal
Connect a ground cable here if necessary.
2—POWER Switch
Use the POWER switch to turn the VS-2000 on. Use it to turn the VS-2000 off after
performing a proper shutdown procedure.
Don't simply flip the POWER switch when you want to shut down the VS-2000—if you
do this, data loss may occur. Make sure to use the proper shutdown procedure,
described on Page 85.
3, 4—DC IN Jack, DC Cord Hook
Connect the supplied AC power adaptor to this jack, and then connect the adaptor's AC
plug to a grounded AC outlet.
Use only the supplied AC power adaptor to prevent damage to your VS-2000.
To prevent the inadvertent disruption of power to your unit should
the plug be pulled out accidentally, and to avoid applying undue
stress to the DC IN jack, anchor the power cord using the cord hook,
as shown in this illustration.
5—USB 2.0 Jack
To connect the VS-2000 to a computer for the exchanging of files, connect the "A" end of
a USB cable to this jack. Connect the "B" end to the computer's USB jack. See Page 81 to
learn about activating and de-activating USB communications.
To help ensure successful USB communication, connect the VS-2000's USB 2.0 jack
directly to a USB jack on your computer. The use of a USB hub is not recommended.
Roland VS-2000 Owner's Manual www.RolandUS.com 47