Master Bus Insert Effects; Inserting Effects On The Master Bus - Roland VS-2000 Owner's Manual

MASTER Bus Insert Effects

Where Effects are Inserted
MASTER bus insert effects are inserted onto the MASTER bus just before its final level
control—the MASTER fader. Use an insert effect on the MASTER bus if an entire mix
needs a particular type of processing.
When you master your final mix in preparation for burning an audio CD or for transfer
to a computer or other external digital audio device, you can apply an insert effect to
the whole mix from within the VS-2000's Mastering Room. The VS-2000 offers a large
collection of Mastering Tool Kit ("MTK") effect patches designed for just this purpose:
to apply the finishing touches to a great mix.
If your VS-2000 is connected to Roland DS-series monitors (Page 75), you can insert a
Speaker Modeling effect patch on the MASTER bus—see Page 224 for details.

Inserting Effects on the MASTER Bus

1. Hold down SHIFT and press CH EDIT•MASTER.
2. Press F2 (FXIns)—the MASTER EFFECT INSERT appears.
3. Select the desired effect's insert assign switch and select:
4. As necessary, use the insert effect's Snd and Rtn controls
5. Repeat Steps 3 and 4 for any other effects you want to
6. Once you've set up your insert effects, select the desired
Roland VS-2000 Owner's Manual
The MASTER EFFECT INSERT screen operates in much the same way as the input and
track channels' EFFECT INSERT screen, though it's a bit simpler: only one insert
routing is needed for each effect since a MASTER bus insert effect always uses both
sides of its processor.
• OFF—so that the effect is not inserted on the
MASTER bus.
• Ins—to insert the effect on the MASTER bus.
to adjust the level of the signal coming into the insert
effect or out of it, respectively.
insert on the MASTER bus.
effect patch for each—see "Selecting Effect Patches" on
Page 219.
Effect 3 is
already inserted
on Track
Channel 4
www.RolandUS.com
16—Using Effects
Insert assign switch
Send level Return level
217