Sending Sysex Bulk Dump Data - Roland VS-2000 Owner's Manual

23—MIDI and Synchronization

Sending SysEx Bulk Dump Data

1. Using a MIDI cable, connect the VS-2000's MIDI OUT/THRU jack to the device to
2. Navigate to the MIDI PARAMETER screen ((Page 283).
3. Set MIDI OUT/THRU to Out.
4. Press F5 (BlkDmp)—the MIDI BULK DUMP screen appears.
5. To include scene data in the dump, turn on the SCENE section's BULK Tx Sw.
6. Set the SCENE section's BULK Tx TARGET parameter to:
7. If you want to include EZ Routing user template data in the dump, turn on the EZR
8. To include one or all of your user effect patches, turn on the Usr FX section's BULK
9. When you've configured the contents of the bulk dump, press F1 (BULKTx) for
10. Press ENTER/YES to transmit the SysEx bulk dump, or EXIT/NO to cancel the
288
which you want to transmit the SysEx bulk dump.
When you bulk-dump data from the VS-2000, all data selected for transmission on
this screen is included in the dump. Therefore, you'll need to select what you want
to transmit in the dump. The screen is divided into three parts: SCENE, EZR Usr
Tmplt ("EZ Routing User Templates") and Usr FX ("User Effect Patches"). Each
section has a BULK Tx ("Bulk Transmit") Sw on/off parameter, and a BULK Tx
TARGET ("Bulk Transmission Target") parameter.
• ALL—to include all of the current project's scenes in the dump.
• (Scene XX)—to select a single scene to dump.
Usr Tmplt section's BULK Tx Sw and select a single EZ Routing template or ALL
templates for its BULK Tx TARGET parameter.
Tx Sw parameter and set its BULK Tx TARGET to ALL or a selected user effect
patch.
"Bulk Transmit."
The VS-2000 asks if you're sure you want to transmit the bulk dump.
operation.
A progress bar appears on the screen as the dump occurs. When the dump is
complete, the VS-2000 displays "Done!"
www.Roland.com Roland VS-2000 Owner's Manual