Roland VS-2000 Owner's Manual page 154

11—Input and Track Channel Tools
14. F.LINK
The F.LINK (for "Fader Link") on/off switch lets you link the FADER parameter
values of odd/even channel pairs. If the current channel is:
•
•
When two channels' FADER values are linked, you can move either fader to control the
output level of both channels simultaneously. This can be handy when you want to
simultaneously adjust the levels of two related channels.
When you link two channels' FADER values, the VS-2000 sets them both to 0dB, or to
their last linked setting. When you un-link the values, they're reset to 0dB.
When two channels are linked, their FADER parameter changes in appearance and
behaves differently. See Page 152.
The F.LINK parameter differs from the ChLink parameter in that it only links the
channels' FADER parameters. All of their other parameters remain independent of
each other.
15. FX INS
Press ENTER/YES to jump to the FX Ins screen to insert an effect on
the channel, or to remove an insert effect. See Page 215.
The FX INS display shows the number of any effect that's been
inserted into the channel's signal flow(Page 88), or "Off" if there are
no effects inserted in the channel.
16. DIR 1-8
Use the DIR 1-8 boxes to assign the channel to any of the eight Direct
paths (Page 207) pre- or post-fader (Page 209).
To assign a channel's signal to a Direct path from a CH EDIT VIEW screen:
1. Select the desired Direct path box.
2. Turn the Time/Value dial so that its number is highlighted.
Only one channel's signal can be routed to a Direct path at a time, it replacing the
channel previously routed to the path. For a list of the channels currently routed to the
Direct paths, press ENTER/YES. Press EXIT/NO to close the list.
17. SOLO
Turn SOLO on to quickly isolate the channel by turning off any other channels
whose SOLO switch is not turned on. To solo multiple channels, you'll find it
quicker to use Solo Mode (Page 142).
When a channel is soloed in Solo Mode, its SOLO switch is automatically turned on.
154
odd-numbered—its FADER value is linked with that of the even-numbered channel
to its right.
even-numbered—its FADER value is linked with that of the odd-numbered channel
to its left.
www.Roland.com
inserted in the
DIR Bus 1 is
selected and
highlighted here.
Roland VS-2000 Owner's Manual
In this
illustration,
Effect 3 is
channel.