Roland VS-2000 Owner's Manual page 196

14—Working with Track Channels
To quickly clear all of the QUICK ROUTING screen's connections, press F4 (AllClr).
3. Press the desired source track channel's TRACK/STATUS button—a virtual wire
4. Repeat Step 3 for any other tracks you want to bounce.
Channels 6 and 7—
Track 1 on the hard
5. When you're done, press F6 (EXIT) to confirm the routing and leave Quick Routing.
Setting Up EZ Routing for a Bounce
1. Press EZ ROUTING.
2. If the ROUTING VIEW screen doesn't appear, and you see "VIEW" above F1, press
3. Use
196
appears on the screen to show the connection you've made.
We pressed
Track Channel
5's TRACK/
STATUS
button.
If you want to break the connection, press SELECT again.
We pressed the
TRACK/STATUS
buttons for Track
we're now
bouncing Track
Channels 5-7 to
disk recorder.
Hard Disk
Recorder
Tracks 1-18
Track
channels
1-18
F1 (VIEW). If you don't see "VIEW" above F1, press PAGE and then F1 (VIEW).
, , and/or
edge of the TRACK MIXER block.
www.Roland.com
to select a source track channel's output along the upper
The gray arrows at the
left edge of the screen
show the direction in
which signal flows.
When you're bouncing
tracks, signal flows up
from the track
channels to the hard
disk recorder tracks.
The gray arrows at the
left edge of the screen
show the direction in
which signal flows.
When you're bouncing
tracks, signal flows up
from the track
channels to the hard
disk recorder tracks.
The gray arrows at the
left edge of the screen
show the direction in
which signal flows.
When you're bouncing
tracks, signal flows up
from the track
channels to the hard
disk recorder tracks.
Roland VS-2000 Owner's Manual