Erasing A Cd-Rw Disk; If You Encounter Error Messages During Cd Burning; The Cd Player Feature - Roland VS-2000 Owner's Manual

27—Mastering and CD-R/RW Operations

Erasing a CD-RW Disk

•
•
•
•
•

If You Encounter Error Messages During CD Burning

The one error messages you're most likely to see during CD burning are the following:
•
The VS-2000 Appendices contain explanations of additional error messages.

The CD Player Feature

You can use your CD-R/RW drive as a CD player that can play CDs that haven't yet
been finalized. It can also play any finalized CD, as well as commercial CD releases.
When you're using the CD Player feature, you can listen through the VS-2000's
MASTER and MONITOR outputs, as well as the PHONES jacks. The CD Player feature
is for listening only—you can't route audio from the CD to tracks for recording, or to
additional VS-2000 output jacks or connectors.
When you're listening to a CD that hasn't yet been finalized, you won't be able to hear
approximately the final .5 seconds of each track.
368
If you attempt to write to a CD-RW that already contains data, the VS-2000 displays:
Finalized Disc! or Not Blank CD!
Press ENTER/YES to proceed. The VS-2000 then displays:
Press ENTER/YES to erase the current contents of the CD-RW disk. The erasing
procedure takes a few moments.
Once the disk's been erased, the VS-2000 shows the same message as in Step 5 on
Page 366. Press ENTER/YES to proceed or EXIT/NO to cancel.
Finally, the VS-2000 asks if you're sure you want to proceed, as in Step 13 above.
Press ENTER/YES to proceed, or EXIT/NO to cancel the operation.
Please Insert CD-R Disc!—If you see this message, there's no CD-R or CD-RW disk in
the burner, the burner's tray isn't closed, or the burner's not ready for use.
www.Roland.com
CD-RW (ReWritable)!!
Erase?
All Data on the CD-RW
will be Erased.
Are You Sure?
Roland VS-2000 Owner's Manual