Table of Contents
Advertisement
2-4 Starting Printing
Getting Ready to Receive Data from a Computer
When you have finished loading media and making the temperature settings for the media heating system, then follow
the steps below. This procedure enables the machine to receive data from the computer and perform printing.
Procedure
–
Close the front cover.
—
Make sure
˜
Wait until
™
Make sure you are at the top menu.
If you are not at the top menu, press
Printing Is Not Possible in These Situations
➢ The machine does not run when the front cover is open. Also, never open it when printing is in progress. Doing so
interrupts printing.
➢ Data from the computer is not accepted when
➢ Printing does not start unti
➢ Data from the computer is not accepted when you are not at the top menu.
Points Which Must Be Observed
➢ Be sure to set the media clamps during printing. Otherwise the edges of the media may warp and catch on the print
heads.
➢ During printing, never touch the media that's already been discharged. Doing so may obstruct media feed or cause
the media to rub against the heads, which may result in a paper jam or damage to the heads.
36
Chapter 2 Operation
lights up.
stops flashing and stays steadily lit.
, then press
lights up.
.
Top menu
is dark.
Steadily lighted
SET UP
Flashing
Steadily lighted
HEATER CONFIG
Advertisement
Table of Contents
