Table of Contents
Advertisement
2-4 Starting Printing
How to Perform Cleaning
When a printing test reveals dot drop-out or the like, perform cleaning for just the group of heads that is incapable of
correct printing. Compared with performing cleaning for all heads, this can reduce the amount of ink consumed.
Procedure
–
—
˜
Group A
™
š
›
Perform a printing test again to make sure the dot drop-out has been corrected.
If the problem persists, try performing cleaning a second time.
If the problem doesn't go away even after performing cleaning two or three times, then try cleaning using a
different method.
P. 54, "When Head Cleaning Is Not Effective"
When you want to clean all heads simultaneously
Hold down
38
Chapter 2 Operation
Group B
Group C
Printing-test results
for one second or longer. Cleaning for all heads starts automatically.
Press
.
Press
.
Use
to choose the group of heads
that is not to be cleaned.
Use
to get rid of the group dis-
play.
Repeat this procedure to display the groups of
only the heads that require cleaning.
Of groups A through C, cleaning is performed only for
the groups displayed.
Press
.
Cleaning starts.
When it finishes, the screen shown in the figure ap-
pears again.
Press
.
Press
to go back to the original screen.
Advertisement
Table of Contents
