Starting Printing; Remaining Ink During Printing - Roland Texart RT-640 User Manual

Printing

Starting Printing

When the operation of
printing. To print, the following procedure is required
Creating printing data
Create printing data using application software such as Adobe Illustrator. For information on how to create
the data, refer to the documentation of your application software.
2
Sending the output data to this machine using the software RIP
For information about installing and using the software RIP, refer to the documentation for the software RIP.
Points that must be observed when printing
 When performing printing, be sure to attach the media clamps. Otherwise the edges of the media
may warp and catch on the print heads.
 During printing, do not touch media that has already been discharged. Doing so may obstruct
media feed or cause the media to rub against the print heads, which may result in a paper jam
or damage to the heads.
 When not using the machine, raise the loading lever.

Remaining Ink during Printing

Ensure there is sufficient remaining ink
When the ink in the subtanks runs out (or, if using 4 colors, when all inks of the same color run out) during print-
ing, printing pauses. When printing pauses, the coloring at the seam may be altered when printing resumes.
Before performing printing, check the amount of ink remaining in the ink pouches by examining them to see
how full they are. Take care particularly when performing lengthy printing.
P. 54"Out-of-ink Warnings", P. 55"Ink Pouch Replacement"

48
P. 47"Getting Ready to Receive Data from a Computer"
is completed, it is possible to start