Expanding The Printing Area By Reducing The Margins - Roland Soljet Pro III XJ-740 User Manual

5-2 Setting the Printing Position and Margins
Description
You can shift the printing position to the left by using
individual page. When the printing of one page finishes, the left-right positioning returns to its default value. When the
position has been set,
This feature is also available when printing various test patterns, and can help you use media with less waste. Note,
however, that the left and right positions are not restored to their defaults for test patterns.

Expanding the Printing Area by Reducing the Margins

Procedure
–
—
˜
™
Description
This makes the setting for distance from the left or right media clamp to the corresponding left or right edge of the
printing area. You can select either "5 mm" or "10 mm." Setting this to "5 mm" lets you expand the printing area.
P. 119 "Printing Area and Margins"
Note, however, that when you're using transparent media, setting this to "5 mm" may result in printing on top of the
media clamps.
Changing the setting while
redo the preparations for printing.
Default Setting
[SIDE MARGIN]: 10 mm
70 Chapter 5 Feature Reference
lights up and the screen displays the printable width at the set position.
Press .
Press several times.
Press .
Press several times.
Press .
Use
Press to enable the setting.
The settings are saved and the screen shown in the figure appears.
is lighted makes
. Note, however that this setting must be made for each
to select [5 mm].
go dark. To start printing, press once more and