3-2 Using the Take-up System
Loading Roll Media
1.
Pass the media through the printer.
Load the roll media.
P. 28, "Loading Media "
2.
Fasten the media to the paper tube.
When you attach the paper tube, insert it securely onto the end caps on the take-up unit. For information on how to
install it, refer to the Setup Guide.
Dancer roller
Loading lever
Move the dancer roller toward the rear.
Pull back the loading lever.
The media is secured in place.
Use
to select "TU."
Press
.
The screen shown in the figure appears.
Press
to adjust the length of the media to
be pulled out.
You can adjust the length of the media in 10-millime-
ter steps by pressing
(To pull out media continuously, hold down
Chapter 3 Operation of the Media Take-up System
.
. )
45