Table of Contents
Advertisement
5-5 Optimizing Printing to Match Media Thickness
To make the setting for the correction value even more accurate, we recommend carrying out the following before
printing the test pattern.
➢ After loading the media, use
P. 69, "Shifting the Print-start Position Forward or Backward"
➢ Set the print-start position near the center of the media.
P. 69, "Shifting the Printing Position to the Left"
Note, however, that you can also make this setting on the computer (by, for example, choosing the media type in the
software RIP you are using). When you have made the setting on the computer, the computer's setting is used and the
printer's setting is ignored.
Default Setting
[SETTING]: 0.00%
Changing the Feed-correction Value During Printing
Procedure
–
—
˜
Description
If white or dark-colored stripes appear during printing,you can change the feed-correction value without stopping the
printing operation in progress.If white horizontal stripes appear,you make the correction value smaller.If dark horizon-
tal stripes appear,you make the value larger.You can change the correction value regardless of whether settings made
on the machine or settings made on the computer take precedence.
A correction value set while printing is in progress is saved only as a setting on the machine.
86
Chapter 5 Feature Reference
to feed out the media by about one meter.
Print-start position
While printing is in progress, press
Press
.
The current correction value is displayed.
Use
to set the correction value.
Press
to enable the setting.
The changed correction value is saved and immediately applied to printing.
Approx. 1 m
.
Advertisement
Table of Contents
