The Machine Doesn't Run; The Printer Unit Doesn't Run; The Media Take-Up System Doesn't Run; The Media Heating System Doesn't Warm Up - Roland Soljet Pro III XJ-740 User Manual

6-1 The Machine Doesn't Run

The Printer Unit Doesn't Run

Is the power switched on?
Switch on the printer's main power, then press the sub power
switch and make sure the sub power switch lights up.
Is illuminated?
Printing is not performed when
Pull back the loading lever, close the front cover, and press
.
Is the front cover open?
Close the front cover.
Is the top menu displayed?
If the top menu isn't displayed, printing doesn't start even
when data is sent from the computer. To go to the top menu,
press , then press
P. 36, "Getting Ready to Receive Data from a Computer"
Is illuminated?
When lights up, operation is paused. To resume,
press .
Has ink run out?
and a warning beep sounds. At the same time, operation
pauses. When the ink cartridge is replaced with a new one,
printing starts.
P. 39 "If Ink Runs Out"
P. 77, "Determining What Happens When an Ink Cartridge Is Empty"
Is a message displayed on the screen?
P. 113, "If a Message Appears"
P. 114, "If an Error Message Appears"
Is the power cord connected?
Connect the power cord securely.
Is the Link LED lighted?
If the Link LED for the Ethernet connector is not lighted, it
means that a correct connection to the network has not
been made. Make sure the network routing is suitable. Try
connecting the computer and the machine to the same hub,
or connecting them directly using a crossover cable. If this
makes it possible to perform printing, it means the problem
is in the network itself.
Are the network settings correct?
If printing is not possible even though the Link LED is lighted,
check to make sure the IP address and other such settings
are correct. The settings on both the machine and the com-
puter must be appropriate. Redo the settings, checking to
ensure that the IP address doesn't conflict with the IP ad-
dress for another device on the network, that the port set-
106 Chapter 6 What to Do If
is not illuminated.
.
goes dark and printing resumes.
When printing data is sent while
the screen shown in the figure
is displayed, a message appears
ting for the software RIP specifies the IP address set on the
machine, that the settings have no typing errors, and for
other such problems.
Link LED
Setup Guide
P. 92, "Setting the IP Address, Subnet Mask, Etc."
Did the software RIP end abnormally?
Make sure the software RIP is running correctly, then switch
the sub power switch off and back on.

The Media Take-up System Doesn't Run

Is the take-up unit cable connected?
Connect the take-up unit cable to the machine. To perform
take-up automatically during printing, also make the set-
ting for the AUTO switch.
Setup Guide
P. 45, "Loading Roll Media"

The Media Heating System Doesn't Warm Up

Is media loaded?
The media heating system does not warm up to the preset
temperature when is dark (by default). Load media,
press , and wait for the machine to warm up.
P. 87, "Determining How the Media Heating System Operates"
Is the temperature of the room too low?
Use the machine in an environment where the temperature
is 20 to 32˚C (68 to 90˚F).