Starting Printing - Roland VersaEXPRESS RF-640 User Manual

Starting Printing

When the operation of  P. 42, "Getting Ready to Receive Data from a Computer" is completed, you can
start printing. To print, the following procedures are required.
Creating print data
Create the print data using the application software like Adobe Illustrator and like that. For information on
how to create the data, refer to the documentation of your application software.
Sending the print data to this machine using software RIP.
For information on how to install and use software RIP, refer to the documentation of your software RIP.
 Be sure to set the media clamps during printing. Otherwise the edges of the media may warp and
catch on the print heads.
 During printing, never touch the media. Doing so may obstruct media feed or cause the media to
rub against the print heads, which may result in a paper jam or damage to the print heads.
 Keep the loading lever raised when the machine is not in use.
If Ink Runs Out
When ink runs out, a warning beep sounds and a slot number of which ink runs out is displayed on
the display screen. Exchange the ink cartridge.
 P. 49, "How to Replace Ink Cartridges"
Before you perform lengthy printing, check the amount of ink remaining in the ink car-
tridges.
Before you perform lengthy printing, check the amount of ink remaining in the ink cartridges. When
ink runs out and printing is paused, the coloring at the seam may be altered when printing resumes.
 P. 48, "Checking for Remaining Ink"
Points that must be observed
Printing
2
43