Summary Of Code Command Parameters - Oce XDL Reference Manual

Summary of CODE Command Parameters

2.3 Summary of CODE Command Parameters
A CODE command is referenced by the CODE or LCODE parameters of the VOLUME
command whenever a user-defined code translation table is required.
An identifier label (ac:) is optional for the first CODE command within a JDE. Thereafter,
each additional CODE command within the JDE must be labeled. Therefore, when multiple
CODE commands are available within a JDE or JDL, only one can be unlabeled. The syntax
is ac:CODE.
ASSIGN
DEFAULT
Parameter
ASSIGN=
input,
(out-put
[,output
[,...])
DEFAULT=
code-type
34
This parameter defines user code assignment exceptions, or the entire user char-
acter translation table.
This parameter specifies a base code from which code assignment exceptions can
be made. The base code is specified by a code-type; the exceptions are specified
using the ASSIGN parameter.
Definition(s)
input
Defines the input code.
output
1
] This parameter defines one or more entries to a code-
2
translation table.
The code type can be one of the following
EBCDIC
ASCII
This option defines the basic-volumes of a code-
translation table.
value
A value is a one-byte hexadecimal, octal, or alpha
constant. If a value is specified, all inputs are coded to
the specified value.
The DEFAULT parameter must be coded prior to any
ASSIGN parameter for the assignment exceptions to
come into effect. A DEFAULT parameter following
any defined corresponding ASSIGN input or output
parameter options causes this correspondence to be
replaced by the DEFAULT parameter.
The default is EBCDIC.
Input Processing
Offline Online DJDE
Y Y
Y Y
A29247-X4-X-8-7672
N
N