Points To Note - Oce XDL Reference Manual

Print Processing
Parameter
STAPLE=YES
STAPLE=NO
STOCKS=
stockset-name
UNITS=
size in dots
XMP=
DEFAULT
XMP=
REPORT

3.9.2 Points to note

Note the following when using the OUTPUT command. These points to note list parameters
followed by the applicable action or system response.
A29247-X4-X-8-7672
Summary of OUTPUT Command Parameters (Continuation)
Definition(s)
Specifies stitching and implies NTO1=NO and
COLLATE=YES, but not vice versa. Individual
sheets cannot be offset when coded in the JSL.
Specifies no stitching
This is the default-value.
No Default
This command defines the STOCKSET and it's
associated stock(s) to be used in a report. If the
stockset-name does not refer to a STOCKSET
statement coded earlier in the same JDL, it is as-
sumed, that the STOCKSET exists globally in the
parameter file.
Whenever a new stockset is chosen (i.e. at start
of report or via a DJDE JDE/JDL switch), each
stock is checked to determine that the stock exists
and can be made active. This provides an auto-
matic method of changing stocks in the LPS as re-
quired by the data-stream.
Defines the dot size of a unit used for specifying
the position of a graphic when referenced by the
IMAGE or LOGO parameter on the OUTPUT
command or an IMAGE, ALTER, LOGO or
GRAPHIC DJDE parameter.
size in dots
The size defines the number of dots in one unit
and is specified as a decimal number with up to
two digits to the right of the decimal point. When
used to compute the position of a graphic, the re-
sult is rounded to the nearest dot. A dot is 1/300th
of an inch.
There is no default.
In the LCDS-Module ignored
In the LCDS-Module ignored
Offline Online DJDE
Y Y Y
Y Y N
Y Y Y
119