Table of Contents
Advertisement
Using Logical Processing
In non-delimiter mode (DELIMITER=NO), a single record separates one report from the
next. After satisfying the TEST criteria, this record is considered part of the subsequent re-
port. In this mode the delimiter record cannot be printed to the tray, that is, PRINT option
not available when DELIMITER=NO. It also does not appear on the operator's display.
4.12.2 HJOBNO, HRPTNA display
HJOBNO and HRPTNA may be displayed as part of the jobname in the spoolqueue (see
PRISMAproduction Admnistrators Guide, chapter 'LCDS-Module Operation' -> 'Jobname
Settings').
Note that HJOBNO is not an RSTACK option.
4.12.3 Online RSTACK usage
When using RSTACK online, consider the following:
•
Detection of RSTACK criteria within a not yet recognized banner page (RSTACK record
occurs prior to BANNER criteria line) results in subsequent incorrect report separation.
•
Detection of RSTACK criteria in a recognized but incomplete banner page (RSTACK
record occurs after BANNER criteria line) is ignored.
•
Detection of RSTACK immediately following report separation is ignored. This prevents
null reports. If RSTACK is specified in a selected JDE or JDL, that is, a JDE or JDL in-
voked in a DJDE), the following restrictions to online systems apply:
•
If RSTACK is not specified in the JDE or JDL of the START command, the DELIM-
ITER=NO parameter should be specified in the selected JDE or JDL. Specification
of DELIMITER=YES is overridden.
•
If RSTACK is specified in the JDE or JDL of the START command, the DELIMITER
parameter cannot be changed in a selected JDE or JDL.
•
If DELIMITER=YES is specified, a record that satisfies the TEST criteria of a select-
ed JDE or JDL results in an end of report normally. However, it prints at the start of
the subsequent report unless it also satisfies the TEST (or DJDE) criteria of the
starting JDE or JDL.
•
If RSTACK is specified in the JDE or JDL of the START command but not in the
selected JDE or JDL, RSTACK processing is suspended until end of report is trig-
gered by BANNER page detection.
•
If ACCTINFO is specified in the JDE or JDL of the START command, the ACCTIN-
FO parameter cannot be changed or deleted in a selected JDE or JDL (even if
RSTACK is suspended).
A29247-X4-X-8-7672
RSTACK Command
161
Advertisement
Table of Contents
