Rpage Command - Oce XDL Reference Manual

RPAGE Command

4.11 RPAGE Command
The RPAGE command allows for the repositioning of the current (or next) logical page.
Parameter
SIDE=
side-opt
SIDE=
offside-opt
TEST=
test-opt
158
Definition(s)
side-opt
Available side-opt parameters are: NUFRONT (the
default), BACK, NUBACK, NEXT, FRSHEET, BK-
SHEET.
In duplex (with no BFORM), side-opt produces the fol-
lowing results. If NUFRONT is coded, the specified
logical page is positioned as the first logical page on
a new sheet. If BACK is coded, the specified logical
page is positioned as the first logical page of the next
available back. If NUBACK is coded, the specified
logical page is positioned as the first logical page on
the back of a new sheet. If NEXT is coded, the spec-
ified logical page is positioned as the first logical page
on the next available side, the back of the current
sheet or the front of the next sheet.
The logical page is moved unless it is already proper-
ly positioned as the first logical page on the specified
side.
In simplex, or in duplex with BFORM, the SIDE pa-
rameter defaults to NUFRONT and the specified page
is positioned as the first logical page. If the logical
page is already properly positioned, a blank sheet is
not created.
The default is NUFRONT
offside-opt
Available offset-opt parameters are: NOFFSET (the
default), OFFSET. If OFFSET is coded, the sheet on
which the repositioned logical page occurs is offset in
the output stacker. If NOFFSET is coded, no offset
occurs.
The default is NOFFSET. OFFSET has no meaning
for a continuous feed printer, so it is ignored (Some
finishing systems support this function).
test-opt
The format and syntax of a test-exp are defined in the
"Test expression definition" section. The logical page
on which this record normally prints is called the "cur-
rent logical page."
Using Logical Processing
Offline Online DJDE
Y Y
Y Y
A29247-X4-X-8-7672
Y
N