Table of Contents
Advertisement
Summary of OUTPUT Command Parameters (Continuation)
DUPLEX=YES
Any job that runs in simplex mode runs in duplex mode except transparencies.
COLLATE
Once you have specified multiple copies, the value of the COLLATE parameter cannot be
changed again within the report.
CYCLEFORMS, FORMS
Both may be used within a report; however, only the last parameter specified is in effect at
any given time. If a multicopy report specifies CYCLEFORMS, a FORMS DJDE encoun-
tered midreport overrides the CYCLEFORMS parameter from that point in every copy.
RAUX command, FEED parameter of OUTPUT command
If they specify two different cluster names, RAUX has higher priority.
Paper sizes
The PAPERSIZE parameter is not supported as a DJDE. Therefore, a JDE page-oriented
DJDE that calls out the desired paper size is needed.
8.27 X 11.69 versus A4
These two papersizes define the same dimensions but a different edge marking.
PURGE=NO
If a report containing 'inline-resources' is processed and PURGE=NO is set, the operator
has to synchronize the consecutive reports so that a preceding report is completely termi-
nated (printed, stacked and deleted) before a successive report is started.
3.9.3 Examples
This section shows examples of using the OUTPUT command.
Example 1
OUTPUT
DUPLEX=YES, CYCLEFORMS=NONE, FORMAT=PDE1;
120
Print Processing
A29247-X4-X-8-7672
Advertisement
Table of Contents
