Rule Configuration: Application Rule Configuration - ZyXEL Communications NBG4615 User Manual

26.5.1 Rule Configuration: Application Rule Configuration

If you want to edit a bandwidth management rule for a pre-defined service or application, click the
Edit icon in the Application List table of the Advanced screen. The following screen displays.
Figure 126 Bandwidth Management Rule Configuration: Application List
The following table describes the labels in this screen.
Table 80 Bandwidth Management Rule Configuration: Application List
LABEL
#
Enable
Direction
Bandwidth
Destination Port
Source Port
Protocol
Apply
Cancel
NBG4615 User's Guide
DESCRIPTION
This is the number of an individual bandwidth management rule.
Select an interface's check box to enable bandwidth management on that
interface.
These read-only labels represent the physical interfaces. Bandwidth
management applies to all traffic flowing out of the router through the interface,
regardless of the traffic's source.
Traffic redirect or IP alias may cause LAN-to-LAN traffic to pass through the
NBG4615 and be managed by bandwidth management.
Select Maximum Bandwidth or Minimum Bandwidth and specify the
maximum or minimum bandwidth allowed for the rule in kilobits per second.
This is the port number of the destination that define the traffic type, for
example TCP port 80 defines web traffic.
See Appendix F on page 301
This is the port number of the source that define the traffic type, for example
TCP port 80 defines web traffic.
See Appendix F on page 301
This is the protocol (TCP, UDP or user-defined) used for the service.
Click Apply to save your customized settings.
Click Cancel to exit this screen without saving.
Chapter 26 Bandwidth Management
for some common services and port numbers.
for some common services and port numbers.
199