Static Wep - ZyXEL Communications NBG4615 User Manual

Chapter 12 WISP Mode
Table 39 No Security (WISP) (continued)
LABEL
Apply
Cancel

12.5.1 Static WEP

Use this screen if the access point to which you want to connect to uses WEP security mode.
Figure 67 WEP (WISP)
The following table describes the labels in this screen.
Table 40 WEP (WISP)
LABEL
WISP Parameters
SSID
Channel
Selection
Security Mode
PassPhrase
WEP
Encryption
ASCII
Hex
96
DESCRIPTION
Click Apply to save your changes back to the NBG4615.
Click Cancel to reload the previous configuration for this screen.
DESCRIPTION
Enter the name of the access point to which you are connecting.
The range of radio frequencies used by IEEE 802.11b/g/n wireless devices is called
a channel. The device will automatically select the channel with the least
interference.
Select Static WEP to enable data encryption.
Enter a Passphrase (up to 26 printable characters) and click Generate.
A passphrase functions like a password. In WEP security mode, it is further
converted by the NBG4615 into a complicated string that is referred to as the "key".
This key is requested from all devices wishing to connect to a wireless network.
Select 64-bit WEP or 128-bit WEP.
This dictates the length of the security key that the network is going to use.
Select this option in order to enter ASCII characters as WEP key.
Select this option in order to enter hexadecimal characters as a WEP key.
The preceding "0x", that identifies a hexadecimal key, is entered automatically.
NBG4615 User's Guide