Password Screen - ZyXEL Communications NBG4615 User Manual

Chapter 29 Maintenance
The following table describes the labels in this screen.
Table 85 Maintenance > General
LABEL
System Setup
System Name
Domain Name
Administrator
Inactivity Timer
Apply
Cancel

29.4 Password Screen

It is strongly recommended that you change your NBG4615's password.
If you forget your NBG4615's password (or IP address), you will need to reset the device. See
Section 29.8 on page 219
Click Maintenance > Password. The screen appears as shown.
Figure 141 Maintenance > Password
The following table describes the labels in this screen.
Table 86 Maintenance > Password
LABEL
Password Setup
Old Password
New Password
Retype to Confirm
Apply
Cancel
214
DESCRIPTION
System Name is a unique name to identify the NBG4615 in an Ethernet
network.
Enter the domain name you want to give to the NBG4615.
Type how many minutes a management session can be left idle before the
session times out. The default is 5 minutes. After it times out you have to log in
with your password again. Very long idle timeouts may have security risks. A
value of "0" means a management session never times out, no matter how long
it has been left idle (not recommended).
Click Apply to save your changes back to the NBG4615.
Click Cancel to begin configuring this screen afresh.
for details.
DESCRIPTION
Change your NBG4615's password (recommended) using the fields as shown.
Type the default password or the existing password you use to access the
system in this field.
Type your new system password (up to 30 characters). Note that as you type
a password, the screen displays an asterisk (*) for each character you type.
Type the new password again in this field.
Click Apply to save your changes back to the NBG4615.
Click Cancel to begin configuring this screen afresh.
NBG4615 User's Guide