Wisp Mode Status Screen - ZyXEL Communications NBG4615 User Manual

Chapter 12 WISP Mode
The default IP address of the NBG4615 is "192.168.1.1". If you did not change this, you can use the
2
same IP address in WISP Mode. Open a web browser such as Internet Explorer and type
"192.168.1.1" as the web address in your web browser.
If you changed the IP address of your NBG4615 while in Router mode, use this IP address in WISP
Mode. The WISP Mode IP address is always the same as the Router mode IP address.
Note: After clicking Login, the Easy Mode appears. Refer to
Easy Mode screens. Click Expert mode to see the screens described in the
sections following this.

12.4 WISP Mode Status Screen

Click to open the status screen.
Figure 63 Status: WISP Mode
The following table describes the labels shown in the Status screen.
Table 37 Status Screen: WISP Mode
LABEL
Logout
Device Information
Host Name
Firmware Version
92
DESCRIPTION
Click this at any time to exit the Web Configurator.
This is the System Name you enter in the Maintenance > General screen. It is
for identification purposes.
This is the firmware version and the date created.
Section on page 57 for the
NBG4615 User's Guide