Wpa-Psk/Wpa2-Psk - ZyXEL Communications NBG4615 User Manual

Chapter 15 Wireless LAN
Table 47 Network > Wireless LAN > Security: Static WEP (continued)
LABEL
Key 1 to Key 4
Apply
Cancel

15.3.3 WPA-PSK/WPA2-PSK

Select WPA-PSK or WPA2-PSK from the Security Mode list.
Figure 83 Network > Wireless LAN > Security: WPA-PSK/WPA2-PSK
The following table describes the labels in this screen.
Table 48 Network > Wireless LAN > Security: WPA-PSK/WPA2-PSK
LABEL
SSID
Security Mode
WPA Compatible
Pre-Shared Key
Group Key
Update Timer
Apply
Cancel
134
DESCRIPTION
The WEP keys are used to encrypt data. Both the NBG4615 and the wireless
stations must use the same WEP key for data transmission.
If you chose 64-bit WEP, then enter any 5 ASCII characters or 10 hexadecimal
characters ("0-9", "A-F").
If you chose 128-bit WEP, then enter 13 ASCII characters or 26 hexadecimal
characters ("0-9", "A-F").
You must configure at least one key, only one key can be activated at any one
time. The default key is key 1.
Click Apply to save your changes back to the NBG4615.
Click Cancel to reload the previous configuration for this screen.
DESCRIPTION
Select the SSID for which you want to configure the security.
Select WPA-PSK or WPA2-PSK to enable data encryption.
This field appears when you choose WPA2-PSK as the Security Mode.
Check this field to allow wireless devices using WPA-PSK security mode to
connect to your NBG4615.
WPA-PSK/WPA2-PSK uses a simple common password for authentication.
Type a pre-shared key from 8 to 63 case-sensitive keyboard characters.
The Group Key Update Timer is the rate at which the AP sends a new group
key out to all clients.
The default is 3600 seconds (60 minutes).
Click Apply to save your changes back to the NBG4615.
Click Cancel to reload the previous configuration for this screen.
NBG4615 User's Guide