Wps - ZyXEL Communications NBG4615 User Manual

Chapter 8 Easy Mode

8.6.7 WPS

Use this screen to add a wireless station to the network using WPS. Click WPS in the Wireless
Security to open the following screen.
Figure 41 Wireless Security: WPS
The following table describes the labels in this screen.
Table 26 Wireless Security: WPS
LABEL
Wireless Security
WPS
Register
Exit
66
DESCRIPTION
Click this to go back to the Wireless Security screen.
Create a secure wireless network simply by pressing a button.
The NBG4615 scans for a WPS-enabled device within the range and performs
wireless security information synchronization.
Note: After you click the WPS button on this screen, you have to press a similar
button in the wireless station utility within 2 minutes. To add the second
wireless station, you have to press these buttons on both device and the
wireless station again after the first 2 minutes.
Create a secure wireless network simply by entering a wireless client's PIN
(Personal Identification Number) in the NBG4615's interface and pushing this
button.
Type the same PIN number generated in the wireless station's utility. Then click
Register to associate to each other and perform the wireless security
information synchronization.
Click Exit to close this screen.
NBG4615 User's Guide