Wall-Mounting Instructions - ZyXEL Communications NBG4615 User Manual

Table 92 Firmware Features (continued)
FEATURE
DHCP (Dynamic Host
Configuration Protocol)
Dynamic DNS Support
IP Multicast
Logging
PPPoE
PPTP Encapsulation
Universal Plug and Play
(UPnP)

30.9 Wall-mounting Instructions

Complete the following steps to hang your NBG4615 on a wall.
Select a position free of obstructions on a sturdy wall.
1
Drill two holes for the screws.
2
Be careful to avoid damaging pipes or cables located inside the wall
when drilling holes for the screws.
Do not insert the screws all the way into the wall. Leave a small gap of about 0.5 cm between the
3
heads of the screws and the wall.
Make sure the screws are snugly fastened to the wall. They need to hold the weight of the NBG4615
4
with the connection cables.
NBG4615 User's Guide
DESCRIPTION
Use this feature to have the NBG4615 assign IP addresses, an IP
default gateway and DNS servers to computers on your network.
With Dynamic DNS (Domain Name System) support, you can use a
fixed URL, www.zyxel.com for example, with a dynamic IP address. You
must register for this service with a Dynamic DNS service provider.
IP Multicast is used to send traffic to a specific group of computers. The
NBG4615 supports versions 1 and 2 of IGMP (Internet Group
Management Protocol) used to join multicast groups (see RFC 2236).
Use logs for troubleshooting. You can view logs in the Web
Configurator.
PPPoE mimics a dial-up Internet access connection.
Point-to-Point Tunneling Protocol (PPTP) enables secure transfer of data
through a Virtual Private Network (VPN). The NBG4615 supports one
PPTP connection at a time.
The NBG4615 can communicate with other UPnP enabled devices in a
network.
Appendix A Product Specifications
235