Vocal Processor; Chord - GEM Powerstation SK760 Owner's Manual

Vocal Processor

Select the Vocal Processor editor from the main
Edit Effects menu with the cursor buttons ( / )
and press Enter to access the editor.
It is also possible to enter the editor directly us-
ing the Page scroll buttons (
The parameter configuration displayed depends
on the mode selected.
Three operating modes are available: Chord /
Vocoder / Unison.
CHORD (F5)
N.B. THIS MODE IS OPERATIVE ONLY IN
STYLE MODE
CHORD mode recognizes the chords you play
and determines the most appropriate harmony
intervals for your singing. This mode produces
up to four voices according to the recognized
chord and chord type (Close or Smart - see Vo-
cal Processor Edit). The harmonic voices are
generated within the octaves above and below
the input note with two different intervals: one
interval near the input note (Close) and another
further away (Extreme). The interval extensions
vary according to the chord played .
Vocal Processor - Chord mode, Volume option
The four voices can be selected from the six avail-
able:
).
You can regulate the Volume and Pan param-
eters of each single voice (F1/F2).
You can mute or activate the various voices with
the function buttons A-F.
The Harmony parameter controls the general
volume of the Vocal Processor:
The Volume page operates in the same manner
as the same page in «Edit Mixer»; in other words,
you can regulate the levels with the Dial or Sliders.
The Volume and Pan controls are common to all
three operating modes.
Vocal Processor - Chord mode, Pan option
Voice 1 : Extreme Lower octave
Voice 2 : Close Lower octave
Voice 3 : Extreme Upper octave
Voice 4 : Close Upper octave
Main : "doubles" the input voice
Bass : "doubles" the input voice one oc-
tave down.
Ex: an active voice shows the icon
a muted voice shows the icon
Vocal Processor 10•9