Table of Contents
Advertisement
Save operations
The Save procedures operate in the direction
RAM –> Destination where the destination can
be Floppy disk or Hard disk.
The SK760/880 RAM is backed by a recharge-
able battery to safeguard the data when the in-
strument is turned off. For security reasons, how-
ever, it is necessary to store your data to floppy
disk or Hard disk with the Save command. The
RAM should be considered as a work area which
can be continually updated, not as a data stor-
age device.
Have a new or used disk ready to save data to.
These can be SK760/880 format disks or stand-
ard MS-DOS disks for the exclusive storage of
MIDI files. You can also save MIDI Files to
SK760/880 format disks.
Check that the floppy disk is not write protected -
if so, remove the protection beforehand. If you
forget to do this, the instrument will prompt you
with an appropriate message when you attempt
to save to the disk.
Save operations are characterized by an addi-
tional option: the creation of a new Block if nec-
essary.
WARNING - Do not save data to the original
disks supplied with the instrument. As a precau-
tionary measure against data loss, always check
that your original disks are write protected.
THE GENERAL SAVE PROCEDURE
1. Insert the floppy disk into the drive.
2. Press DISK to open the main Save page.
If the main Save page is not shown, use the
page scroll buttons (
If you are working with the Hard Disk, press
DISK and select the HARD DISK option with
soft button F2.
) to open it.
1
2
Disk & Hard Disk 3•15
Advertisement
Table of Contents
