Table of Contents
Advertisement
3. Press ENTER to confirm or ESCAPE to cancel.
As a security measure, a second confirmation re-
quest appears (for security reasons):
4. Press the Soft button F1 (not ENTER) to start the
hard-disk format procedure, or ESCAPE to can-
cel.
HARD DISK CHECK/RECOVERY
This procedure can restore a damaged Hard Disk
to its original status. Damage to the Hard Disk
can be caused by:
•
a power failure during a Save operation;
•
physical defects of the disk.
If the Hard disk is damaged, attempting to ac-
cess it prompts a message similar to the follow-
ing:
Use the following recovery procedure as soon
as possible.
1. Enter «Edit Disk» and go to the «Hard Disk Util-
ity» page.
2. Select «Hard disk check/recovery» .
The following dialog window appears:
3. Press ENTER to start the recovery of the data.
Shortly after, another dialog window appears
similar to the one below:
In this case, the message shows no errors.
In cases where errors exist, make a note of
the numbers shown in the dialog window as
they are useful to provide information for tech-
nical assistance.
• Check version - Version of the test pro-
gram and data recovery.
• Error found - Code relating to the error
found. "None" appears in cases where no
errors are encountered.
WARNING - Never turn off the instrument while
the Hard disk or disk drive are writing data (Save,
Copy, Move, Erase operations).
HARD DISK SLEEP TIME
To avoid hearing the noise caused by the rota-
tion of the hard disk, you can set this parameter
to turn the hard disk off after an operation.
Options: Off (always on), 5 sec ... 60 sec.
Disk & Hard Disk 3•31
Advertisement
Table of Contents
