Installing/Removing/Adjusting The Adjustable Angle Stroller Handles; Installing; Removing - Invacare Spree XT Owner's Operator And Maintenance Manual

Installing/Removing/Adjusting the Adjustable Angle
Stroller Handles
NOTE: For this procedure, refer to FIGURE 6.4.

Installing

1. Remove plug buttons from both back canes.
2. Slide the adjustable height stroller handle into the back canes.
3. Align the mounting holes of the adjustable angle stroller handle and the back cane.
4. Secure adjustable angle stroller handle to the back canes with the two quick‐release
pins (Detail ʺAʺ of FIGURE 6.4).
5. If necessary, adjust the height. Refer to Adjusting on page 56.

Removing

1. Press and hold the buttons on the quick‐release pins
2. Remove the adjustable angle stroller handle from the back cane.
3. Install plug buttons.
DETAIL "A" -
QUICK-RELEASE
PIN INSTALLED
Quick-Release Pin
FIGURE 6.4 Installing/Removing/Adjusting the Adjustable Angle Stroller Handles
Part No 1118364
Stroller Handle
Back Cane
Detent
Ball
NOTE: Plug buttons
not shown for clarity.
55
SECTION 6—BACK/SEAT
Quick-Release
Pins
Back Canes
Spree XT