SECTION 5—ARMS
Models Built
Before 4/5/2010
Backrest
Bracket
Locknuts
NOTE: Seat positioning
strap not shown.
Adjusting the Depth of the Non Flip Back Two Point Arms
NOTE: For this procedure, refer to FIGURE 5.2.
1.
Remove the arms. Refer to the owner's manual, p/n 1154295.
2.
Remove the rear arm socket. Refer to Remove Rear and/or Front Arm Socket on page 21.
3.
Secure the rear arm socket and seat positioning strap (if applicable), forward or back, onto the backrest bracket using
the desired set of mounting holes with two mounting screws, washers, and locknuts.Tighten securely.
4.
Remove the front arm socket. Refer to Remove Rear and/or Front Arm Socket on page 21.
NOTE: When performing STEP 5, ensure to match the adjustment of the rear arm socket so that the armrest will align properly into the
arm sockets
5.
Secure the front arm socket to the seat rail, forward or back, with two mounting screws and locknuts.Tighten securely
6.
Repeat STEPS 2‐5 for the remaining front/rear arm sockets.
Solara®3G/Spree 3G
Washers
Rear Arm
Locknuts
NOTE: Front and rear arm sockets shown in low arm height position. High arm
height position removes/installs in the same manner.
FIGURE 5.1 Remove/Install Non Flip Back Two Point Arms
Mounting
Screws
Socket
Front Arm
Socket
Seat Rail
22
Seat
Models Built
Rail
After 4/5/2010
Mounting
Screw
Locknut
Part No 1160889
Front Arm
Socket