Wps - ZyXEL Communications NBG5715 User Manual

Chapter 7 Easy Mode
Figure 29 Wireless Security
The following table describes the general wireless LAN labels in this screen.
Table 18 Wireless Security
LABEL
Wireless Radio
Wireless
Network Name
(SSID)
Security mode
Wireless
password
Verify
password
Apply
Cancel

WPS

7.5.7 WPS
Use this screen to add a wireless station to the network using WPS. Click WPS in the Wireless
Security to open the following screen.
48
DESCRIPTION
Choose whether you want to apply the wireless security to 2.4G hz or 5G hz
wireless radio.
(Service Set IDentity) The SSID identifies the Service Set with which a wireless
station is associated. Wireless stations associating to the access point (AP) must
have the same SSID. Enter a descriptive name (up to 32 keyboard characters) for
the wireless LAN.
Select WPA-PSK or WPA2-PSK to add security on this wireless network. The
wireless clients which want to associate to this network must have same wireless
security settings as this device. After you select to use a security, additional options
appears in this screen.
Select No Security to allow any client to connect to this network without
authentication.
This field appears when you choose wither WPA-PSK or WPA2-PSK as the
security mode.
Type a pre-shared key from 8 to 63 case-sensitive keyboard characters.
Type the password again to confirm.
Click Apply to save your changes back to the NBG5715.
Click Cancel to close this screen.
Click this to configure the WPS screen.
You can transfer the wireless settings configured here (Wireless Security screen)
to another wireless device that supports WPS.
NBG5715 User's Guide