2.3 WPS Button
You can use the WPS button to quickly set up a secure WiFi connection between the Multy Device and
a WPS-compatible client device by adding one device at a time. See
information.
To activate WPS:
1 Make sure the LED lights turns steady blue and not blinking.
2 Press the WPS button until the LED light blink pink and release it.
3 Press the WPS button on another WPS-enabled client device within range of the Multy Device within
120 seconds. The LED blinks pink while the Multy Device sets up a WPS connection with the other WiFi
client device.
4 Once the connection is successfully made, the LED turns steady lake green
2.4 Reset Button
If you need to return the Multy Device to its default settings, use the reset button on the rear panel.
Figure 22 WSQ60/WSQ50 Reset Button
Figure 23 WSQ20 Reset Button
Chapter 2 Hardware
Multy WiFi System User's Guide
24
Table 1 on page 9
for more