Chapter 9 Tutorials
9.3 Configure Wireless Security without WPS
This example shows you how to configure wireless security settings with the following parameters
on your NBG5715.
Wireless LAN Mode 2.4G
SSID
Channel
Security
Follow the steps below to configure the wireless settings on your NBG5715.
The instructions require that your hardware is connected (see the Quick Start Guide) and you are
logged into the Web Configurator through your LAN connection (see
Open the Configuration > Wireless LAN 2.4G > General screen in the AP's Web Configurator.
1
Confirm that the status of wireless LAN is enabled.
2
Enter SSID_Example3 as the SSID and select Channel-06 as the channel.
3
Set security mode to WPA-PSK and enter ThisismyWPA-PSKpre-sharedkey in the Pre-Shared
4
Key field. Click Apply.
60
SSID_Example3
6
WPA-PSK
(Pre-Shared Key: ThisismyWPA-PSKpre-sharedkey)
Section 4.2 on page
29).
NBG5715 User's Guide