Password Screen - ZyXEL Communications NBG5715 User Manual

Chapter 22 Maintenance
The following table describes the labels in this screen.
Table 69 Maintenance > General
LABEL
System Name
Domain Name
Administrator
Inactivity Timer
Apply
Cancel

22.4 Password Screen

It is strongly recommended that you change your NBG5715's password.
If you forget your NBG5715's password (or IP address), you will need to reset the device. See
Section 22.7 on page 163
Click Maintenance > Password. The screen appears as shown.
Figure 104 Maintenance > Password
The following table describes the labels in this screen.
Table 70 Maintenance > Password
LABEL
Password Setup
Old Password
New Password
Retype to Confirm
Apply
Cancel
160
DESCRIPTION
System Name is a unique name to identify the NBG5715 in an Ethernet
network.
Enter the domain name you want to give to the NBG5715.
Type how many minutes a management session can be left idle before the
session times out. After it times out you have to log in with your password
again. Very long idle timeouts may have security risks. A value of "0" means a
management session never times out, no matter how long it has been left idle
(not recommended).
Click Apply to save your changes back to the NBG5715.
Click Cancel to begin configuring this screen afresh.
for details.
DESCRIPTION
Change your NBG5715's password (recommended) using the fields as shown.
Type the default password or the existing password you use to access the
system in this field.
Type your new system password (up to 30 characters). Note that as you type
a password, the screen displays an asterisk (*) for each character you type.
Type the new password again in this field.
Click Apply to save your changes back to the NBG5715.
Click Cancel to begin configuring this screen afresh.
NBG5715 User's Guide