Add/Edit Static Route - ZyXEL Communications NBG5715 User Manual

Chapter 16 Static Route
Figure 71 Network > Static Route
The following table describes the labels in this screen.
Table 50 Network > Static Route
LABEL
Add Static
Route
#
Status
Name
Destination
Subent Mask
Gateway
Modify
Apply
Cancel

16.2.1 Add/Edit Static Route

Click the Add Static Route button or a rule's Edit icon in the Static Route screen. Use this screen
to configure the required information for a static route.
Figure 72 Static Route: Add/Edit
112
DESCRIPTION
Click this to create a new rule.
This is the number of an individual static route.
This field indicates whether the rule is active (yellow bulb) or not (gray bulb).
This field displays a name to identify this rule.
This parameter specifies the IP network address of the final destination. Routing is
always based on network number.
This parameter specifies the IP network subnet mask of the final destination.
This is the IP address of the gateway. The gateway is a router or switch on the
same network segment as the device's LAN or WAN port. The gateway helps
forward packets to their destinations.
Click the Edit icon to open a screen where you can modify an existing rule.
Click the Remove icon to delete a rule from the NBG5715.
Click Apply to save your changes back to the NBG5715.
Click Cancel to begin configuring this screen afresh.
NBG5715 User's Guide