ZyXEL Communications NBG5715 User Manual page 18

Chapter 1 Introduction
Figure 3 Front Panel
WPS
Button
The following table describes the LEDs and the WPS button.
Table 1 Front panel LEDs and WPS button
LED
WPS Button
Power
WAN
Internet
WLAN 2.4/5G
LAN 1-4
USB 1-2
18
Power
Internet
WAN
LAN 1-4
STATUS DESCRIPTION
Press this button for 1 second to set up a wireless connection via WiFi Protected Setup
with another WPS-enabled client. You must press the WPS button on the client side within
120 seconds for a successful connection. See
page 57 for more information on WPS.
On The NBG5715 is receiving power and functioning properly.
Off The NBG5715 is not receiving power.
On The NBG5715's WAN connection is ready.
Blinking The NBG5715 is sending/receiving data through the WAN with a 1000Mbps
transmission rate.
Off The WAN connection is not ready, or has failed.
On The NBG5715 has an IP connection but no traffic.
Your device has a WAN IP address (either static or assigned by a DHCP
server), PPP negotiation was successfully completed (if used) and the
connection is up.
Blinking The NBG5715 is sending or receiving IP traffic.
Off The NBG5715 does not have an IP connection.
On The NBG5715 is ready, but is not sending/receiving data through the 5G
wireless LAN.
Blinking The NBG5715 is sending/receiving data through the 5G wireless LAN.
The NBG5715 is negotiating a WPS connection with a wireless client.
Off The wireless LAN is not ready or has failed.
On The NBG5715's LAN connection is ready.
Blinking The NBG5715 is sending/receiving data through the LAN with a 1000Mbps
transmission rate.
Off The LAN connection is not ready, or has failed.
On The NBG5715 has a USB device installed.
Blinking The NBG5715 is transmitting and/or receiving data from routers through an
installed USB device.
Off There is no USB device connected to the NBG5715.
WLAN 2.4G
WLAN 5G
WPS
Chapter 2 on page 21
USB 1-2
and Chapter 9 on
NBG5715 User's Guide