Clearing And Resolving Alarms; Enabling Alarms To Inads By Way Of A Modem; Enabling Alarms To Inads By Way Of The Snmp Module - Avaya S8400 Installing & Configuring

Note:
The daylight savings rule setting on this form is the rule that is utilized by the
Note:
Communication Manager software. Additional daylight savings rules can be
implemented for the specific locations of hardware supported by the
Communication Manager software. For more information, see
necessary)

Clearing and resolving alarms

1. On the Maintenance Web Interface, under Alarms, click Current Alarms.
You can resolve alarms on the active server only.
2. Select the server alarms to clear and click Clear.
3. Using SAT commands or other standard troubleshooting procedures, to resolve any major
alarms.

Enabling alarms to INADS by way of a modem

1. Start an SSH session on the server.
2. Type almenable -d b and press Enter
3. To verify that the alarms are enable

Enabling alarms to INADS by way of the SNMP module

Note:
Perform this procedure only if the installation includes a Secure Service Gateway
Note:
(SSG).
To enable alarms on the servers:
1. Start an SSH session on the server.
2. Type almsnmpconf -d ipaddress -c communityname and press Enter, where
ipaddress is the trap receiver address for the SSG device and communityname is the
community string name that the SSG device requires.
Installing and Configuring the Avaya S8400 Server
on page 53.
d,
.
type almenable and press Enter
Clearing and resolving alarms
Setting locations (if
.
January 2008
55